What did you do to your bike today?

[Raydub]

First Oil Change wow another blurry photo , i suck..

[ars0n]

android phone? hold the button down till it focuses then let go =D

looks good though, how was it for your first oil change =D

[JetMech]

Picked it up from Steve at Dyno tech. Started bike. Rev'ed it up and realized it's been a year and a half since I threw a leg over it. Rode it down the street and back. Parked it. Now to decide if I should make it a track bike, street bike, or sell it

[The Doctor]

(05-29-2015 10:52 AM)JetMech Wrote:  Picked it up from Steve at Dyno tech. Started bike. Rev'ed it up and realized it's been a year and a half since I threw a leg over it. Rode it down the street and back. Parked it. Now to decide if I should make it a track bike, street bike, or sell it

Or the most likely one: let it sit for another year and a half.

[Raydub]

(05-28-2015 08:22 AM)ars0n Wrote:  android phone? hold the button down till it focuses then let go =D

looks good though, how was it for your first oil change =D

no problems, just about 6 quick fastener screws to take off and thats it. Only other thing to do for brake in is it says to "fuel injection : adjust synchronization" not really sure what that is, im going to need to do some searching online for that.

[Rev. That Guy]

(05-29-2015 10:52 AM)JetMech Wrote:  Picked it up from Steve at Dyno tech. Started bike. Rev'ed it up and realized it's been a year and a half since I threw a leg over it. Rode it down the street and back. Parked it. Now to decide if I should make it a track bike, street bike, or sell it

oh shit son!!! got it running now? nice.

Installing HID headlights today on Elsa. Did a good wipe down of Tia and topped up the tires.

Gonna work a bit more on the 83 magna today as well. Mounted some take-offs to the 83 as the old tires wouldn't hold air. I finally got back to the front wheel swap so now turning a 19" wheel up front instead of an 18. The design is the same as the stock wheel as the 19 came from a same-year CB550SC so it looks a bit cooler with the big wheel and one rotor instead of 2. Hopefully the one will offer enough braking power. Now to pull the carbs again, replace the coolant tube o-rings and put it all back together. Then its fuel lines, fuel pump, filters, and clean out the aux tank and pray it isnt full of too much rust.

Also picking up a ninja 500 to get running for a guy. Already did his carbs but now needs oil change and suspension work. Should be an action packed day.

Also getting ready for a morning ride up the mountain with some work buddies that ride.

- Justin

[Raydub]

Fender elim, hotbodies slip on, putting frame sliders on tonight, and going to replace the hotbodies slip on for a two bros cat elim slip on tomorrow. (and couple little things, ram stem mount, and strapped my backpack to the back.)
yey not a blurry photo

[Junior]

Installed a new power commander v. Bike runs a whole lot better!

[Junior]

Next on the list is valve adjustment, a mannual cct and a re-map with a dyno tune.

[Raydub]

sweet junior, i need a pc5 now.. Just swapped the junk hotbodies slip on for a two brothers cat elim slip on. + frame sliders.
Video of it blowing flames :o



.