Hand grip replacement

[Tat2dAces]

Bought new grips for my zx6r. Any advice as to changing them. Do the new ones need to be glued on or will just sliding them on dry be suffice. Thank you for any input.

Frank

[Rev. That Guy]

dry is best. They will hold just fine. If you cant get them to go on, sometimes using a little bit of hair spray works great as it acts as a lubricant to get them on then dries as a glue to hold them. Again, try dry though. If you have access to an air compressor, a blast of air will make your life a lot easier in getting the old grips off an putting the new ones on.

- Justin

[Tat2dAces]

ty so much for the advice. I will give that a try.

[Rev. That Guy]

if not let me know and I can do it for you... cost ya a couple of red bulls

- Justin

[LVNeptune]

Do the throttle side first so you can get it as good as you want then the other side to line it up

[Tat2dAces]

installation complete. Thx for all the advice.

[JetMech]

Just saw this. I used hairspray. Slides right on then locks in place. Oh well. There's more than one way to skin a cat.

[Rev. That Guy]

glad you got it sorted.

- Justin